Form for Placed in Service/Inspection Report for Refined Petroleum Products

Agr 1405.37 Form for Placed in Service/Inspection Report for Refined Petroleum Products. (a) In addition to other requirements set by rule, statute, or other law, each registered service technician shall complete and submit “Placed in Service/Inspection Report Form RPP/TC-10-02 (Rev. 07/14)” to the department. (b) A registered service technician shall furnish the following on “Placed in Service/Inspection Report Form RPP/TC-10-02 (Rev. 07/14)”: (1) Name of business; (2) Full address, including city, state, and zip code; (3) The following information about each refined petroleum products device at the business: a. Whether installed; b. Whether repaired; c. Whether tested and calibrated for device license; d. Make of meter; e. Serial number of meter; f. Model number of meter; g. Size; h. Make of register; i. Minimum and maximum marked discharge rates; j. Meter location; k. Product; l. Identify all accessories; m. Start and finishing totalizer readings; and n. Tolerance applied; (4) The following information about each test data: a. Type of test; b. Actual discharge rate; c. Totalizer reading start; and d. Totalizer reading finish; (5) The following information about each prover data: a. Prover temperature; b. Prover reading; c. Correction for expansion/contraction of prover; d. Volume correction for prover reading; and e. Prover reading corrected to 60 degrees Fahrenheit; (6) The following information about each meter data: a. Gross meter reading; and b. Net meter reading; (7) If an uncompensated run or systems that give both gross and net readings, the following: a. Average meter temperature; b. Volume correction for meter reading; and c. Meter reading corrected to 60 degrees Fahrenheit; (8) Net delivery error; and (9) Correct gross delivery error. Source. (See Revision Notes #1 and #2 at chapter heading for Agr 1400) #12424, eff 12-1-17